Hi,
Been diving my Waterproof D7 ISS Pro Cordura today and the brass zipper is frayed and delaminating from the metal. Had the suit for seven years and has done around 130 dives. Have been trimming and burning away the fray material carefully the past few dives, but it is continuing to break down. At this point the zip fabric has lost so much material that it is no longer to seal and the suit is leaking in that area. A zipper replacement is needed and now obtaining quotes.
What concerns me is that ans a front-zip drysuit, the area of wear is exactly where my weight belt is located. Even with the plastic zipper cover over the brass zipper, I think pressure and abrasion over time is damaging the zip's seal.
Been thinking that even if I get my drysuit zip replaced, the wear will happen again eventually in a 100-150 dives.
Have noticed that on the newer Waterproof D7X Cordura, the front zip is being higher up (and I think it will avoid the pressure and abrasion caused by the weight belt.
New suit: D7X Cordura - Waterproof Diving
Was wondering if anybody know whether the new Waterproof D7X (Cordura or Nylotech) front zip placement is away from the weight belt?
Note: Despite the weight and bulk of the Cordura Waterproof D7 Pro, the suit has performed very well until the zip failure. Logically I would go with the newer D7X Cordura; but have been eyeing the D7X NyloTech. For this kind of suit, there is a newer version available D7 Evo with a soft YKK Aquaseal Plastic zip vs brass metal zip.
Been diving my Waterproof D7 ISS Pro Cordura today and the brass zipper is frayed and delaminating from the metal. Had the suit for seven years and has done around 130 dives. Have been trimming and burning away the fray material carefully the past few dives, but it is continuing to break down. At this point the zip fabric has lost so much material that it is no longer to seal and the suit is leaking in that area. A zipper replacement is needed and now obtaining quotes.
What concerns me is that ans a front-zip drysuit, the area of wear is exactly where my weight belt is located. Even with the plastic zipper cover over the brass zipper, I think pressure and abrasion over time is damaging the zip's seal.
Been thinking that even if I get my drysuit zip replaced, the wear will happen again eventually in a 100-150 dives.
Have noticed that on the newer Waterproof D7X Cordura, the front zip is being higher up (and I think it will avoid the pressure and abrasion caused by the weight belt.
New suit: D7X Cordura - Waterproof Diving
Was wondering if anybody know whether the new Waterproof D7X (Cordura or Nylotech) front zip placement is away from the weight belt?
Note: Despite the weight and bulk of the Cordura Waterproof D7 Pro, the suit has performed very well until the zip failure. Logically I would go with the newer D7X Cordura; but have been eyeing the D7X NyloTech. For this kind of suit, there is a newer version available D7 Evo with a soft YKK Aquaseal Plastic zip vs brass metal zip.