Well my F2s arrived can't say I'm overly impressed with the finish not sure what's going on with the monoprene and/or the moulding. They have pits in them, the finish is not consistent they have shiny parts, dull parts, vertical lines, horizontal lines, swirls going in all different directions. Had I have seen them first hand I probably wouldn't have bought them, in a word they look "rough". I'm wondering if anyone was doing a QC check prior to leaving the factory.
The sizing is a little off it was recommended that I buy the small but even with the springs adjusted to their tightest position they only just fit in fact quite possibly too loose. They are a very large small. I'm a US 6.5 and wear 5mm boots.
I only hope they dive better than they look and fit. I'll find out Sunday so will post impressions after getting them wet.
Hmmm....Over all so far a little dissapointed given their cost. I expected better quality from Hollis.