felixtibs
Registered
Hey All,
Long time lurker first time poster. New to underwater photo so I put a DC28 housing on my G10. I linked up the nano strobe with a sync cable(fiber optic) and it works perfectly....in my house. Then when I take it to the dive site it wont fire at ALL in or out of the water! The only thing I can think of is the ambient light is causing it not too fire...I dont know!
I am shooting with the pre-set underwater setting which works for me and the flash is either set to always on OR off if I do not want flash. Again, the flash does sync perfectly at home with those settings...it just WILL NOT fire when either underwater or during my predive check...
here is a pic of the rig MINUS the sync cable:
Any ideas?
Long time lurker first time poster. New to underwater photo so I put a DC28 housing on my G10. I linked up the nano strobe with a sync cable(fiber optic) and it works perfectly....in my house. Then when I take it to the dive site it wont fire at ALL in or out of the water! The only thing I can think of is the ambient light is causing it not too fire...I dont know!
I am shooting with the pre-set underwater setting which works for me and the flash is either set to always on OR off if I do not want flash. Again, the flash does sync perfectly at home with those settings...it just WILL NOT fire when either underwater or during my predive check...
here is a pic of the rig MINUS the sync cable:
Any ideas?
Last edited: