eelnoraa
Contributor
By the center hole gormet, I mean the metel gormet in the webbing which line up with the top bolt hole on the backplate. Basically, I am swapping out a dive rite basic harness with a stiffer webbing. Can I just drill a hole in the webbing? Or do I need to have the metal gormet installed? If so, where can I find that kind of hardware?
As for why I want to swap out the DR harness, I think I complained before. The DR webbing is just so soft and sloppy. It doesn't stay flat once wet, so things slide around. I have to make adjustment before every dive to make sure the D-rings are in the right places, left and right should straps are of the same length. This harness is only 3 monthes old and I have only used it with single tank. Absolutely no excuse for having such a bad quality webbing. I think DR should replace it. But for $10, I dont want to bother. it is just a hassle.
As for why I want to swap out the DR harness, I think I complained before. The DR webbing is just so soft and sloppy. It doesn't stay flat once wet, so things slide around. I have to make adjustment before every dive to make sure the D-rings are in the right places, left and right should straps are of the same length. This harness is only 3 monthes old and I have only used it with single tank. Absolutely no excuse for having such a bad quality webbing. I think DR should replace it. But for $10, I dont want to bother. it is just a hassle.
Last edited by a moderator: