Chilly_Dipper
Contributor
Thought I would post this since I've got about 40 dives on it and I'm extremely happy with the results.
The back story
I purchased a Hog Morph 1000 system about a year ago from HOG and got one of the neoprene mitts with it. After attempting to use the light with the supplied glove a couple time I quickly realized the design was really not a good one for cold water divers such as myself, so I sat down and designed a more compatible good man handle for cold water divers. Below are my results
Basically the total cost for the handle was $3 (that's including $1 to replace a broken drill bit) excluding the bolt snap. Bill of materials was:
1 PVC cutting board purchased at dollar store $1
1 supposedly stainless split ring $0.5
2 zip ties .20
and finally about 1 foot of bungee @ $0.5
Took about 1/2 in the shop with a drill press to complete this. Let me know what you think.
The entire proect was completed using a drill press.
The back story
I purchased a Hog Morph 1000 system about a year ago from HOG and got one of the neoprene mitts with it. After attempting to use the light with the supplied glove a couple time I quickly realized the design was really not a good one for cold water divers such as myself, so I sat down and designed a more compatible good man handle for cold water divers. Below are my results
Basically the total cost for the handle was $3 (that's including $1 to replace a broken drill bit) excluding the bolt snap. Bill of materials was:
1 PVC cutting board purchased at dollar store $1
1 supposedly stainless split ring $0.5
2 zip ties .20
and finally about 1 foot of bungee @ $0.5
Took about 1/2 in the shop with a drill press to complete this. Let me know what you think.
The entire proect was completed using a drill press.