i can no longer switch from Imperial to Metric.
when i do Mode-Set-Set Pref the only option that came up were Light and Model.
according to the LDS i sent it to, they'd have to get the 'card' (i assume this means the IC and PCB) changed, which would cost me pretty close to what i could get a D3 for.
my Vyper is > 2 yrs old, and the warranty card is nowhere to be seen.
so, in your experience, is PCB replacement about the only thing that can be done ? i tried to see if the Units switch can be done using SDM but couldn't find the option to do so.
thanks for the help.
p/s i like using metric - simpler calc for figuring out air consumption pressure, etc, though i do think imperial for rec limits.
when i do Mode-Set-Set Pref the only option that came up were Light and Model.
according to the LDS i sent it to, they'd have to get the 'card' (i assume this means the IC and PCB) changed, which would cost me pretty close to what i could get a D3 for.
my Vyper is > 2 yrs old, and the warranty card is nowhere to be seen.
so, in your experience, is PCB replacement about the only thing that can be done ? i tried to see if the Units switch can be done using SDM but couldn't find the option to do so.
thanks for the help.
p/s i like using metric - simpler calc for figuring out air consumption pressure, etc, though i do think imperial for rec limits.