Paul Desmarais
Registered
Looking for Poseidon Jet Stream first stage, with or without seconds.
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
@Paul Desmarais,
I have a Poseidon Odin/Jetstream 1st stage (model #3960, pictured) that I would consider parting with. I purchased it new ca. 1995, and it was used very briefly for back gas (until I very shortly purchased a second complete Poseidon Odin for this), and then (briefly) as an Ar reg, and then kept as a spare.
When it was used, it was used in OH quarries or the Great Lakes, only.
My Odin/Jetstreams were purchased to be used on PST HP100/120 manifolded doubles pumped to 4,000 psig, in the Great Lakes, for "advanced deep air", extended range dives. I would take them a "bit" deeper than 200 ffw. They were recommended to me by experienced divers doing these deep Great Lakes shipwreck dives, and the Odins performed flawlessly.
I ceased using my Poseidon Odins, essentially, in the early 2000's.
If you're interested, DM me.
rx7diver
I think I would prefer to replace my first stage with an Odin/Jet Stream as opposed to purchasing Cyclon second stages.I have a #2950 first stage and three Cyklon seconds stages.
The "Thor" was simply a Jetstream regulator attached to, typically, a 2940, a slightly more modern version of that first stage in your photos -- virtually, the same guts, though. Every Poseidon second stage can be used with any of their first stages.I have shower head second stages.
Ideally I would like to buy a first stage compatible with those second stages.