DSJ
Guest
I can only move my tank up so far on my BC due to the molded backpack, so I use two ankle weights around the tank neck to trim out. It works fairly well, but it does make turning the tank knob a bit more difficult as they ride up fairly close under it.
In my 3mm suit I only need a couple 2lb weights in my ditchable pockets so I don't have anything to move to the trim pockets on the BC. They are fairly low anyway so wouldn't have much of an effect.
I was wondering if there is any manufactured or DIY weight that does the same job with a smaller profile?
David.
In my 3mm suit I only need a couple 2lb weights in my ditchable pockets so I don't have anything to move to the trim pockets on the BC. They are fairly low anyway so wouldn't have much of an effect.
I was wondering if there is any manufactured or DIY weight that does the same job with a smaller profile?
David.