Looking to purchase a DS160 (4060) (w/charger (4066)), DS51 (4044), SA-100s (4086.61) with the 4103.52 connector (housing to 2 DS), which will be connected to a Canon XTi housing. From previous threads and the Ikelite site it looks like the remote sensor was discontinued and the EV controller is not necessarily recommended for this configuration. Wanted to confirm this is the best recommendation and setup. Also, have a question regarding the 4103.52 to ensure I understand setup and operation. Below is an exceprt from from the Ikelite FAQs. Do I understand correctly that if I use the DS160 as the primary, then on the 4103.52, there will be a connector with a red band that I should connect the DS51? Thanks in advance for your assistance.
Which is the Primary Strobe?
The camera can not receive ready-light information from two strobes. If you turn "off" one of the strobes when two are connected, it must be the strobe that is connected to the "non-ready-light" secondary connector identified by the red band. Logic would indicate red for the primary side, but Ikelite has it backwards, putting the red band on the secondary side. This should help you remember.
Which is the Primary Strobe?
The camera can not receive ready-light information from two strobes. If you turn "off" one of the strobes when two are connected, it must be the strobe that is connected to the "non-ready-light" secondary connector identified by the red band. Logic would indicate red for the primary side, but Ikelite has it backwards, putting the red band on the secondary side. This should help you remember.