Anyone run into this or report this as a bug? It's the first time it has happened to me. Hopefully just a glitch but an odd one at that..
I was doing a dive today which involved 3 gas switches (30%, 50%, 100%). Everything worked fine for Gas 1 (bottom gas) and Gas 2 (Nitrox 50%) however as soon as I switched the computer to Gas 3 (100%) all the gases on the DG03 reset back to Air and left me with a 25 minute deco obligation.
Luckily I had backup computer (DG02) which cleared deco with no issues and tables cut with vPlanner so everything else was uneventful in that but obviously computer is now showing a violation and thinks i'm bent like pretzel
Anyone ever had this happen with a DG03 where it lost programmed gases?
I was doing a dive today which involved 3 gas switches (30%, 50%, 100%). Everything worked fine for Gas 1 (bottom gas) and Gas 2 (Nitrox 50%) however as soon as I switched the computer to Gas 3 (100%) all the gases on the DG03 reset back to Air and left me with a 25 minute deco obligation.
Luckily I had backup computer (DG02) which cleared deco with no issues and tables cut with vPlanner so everything else was uneventful in that but obviously computer is now showing a violation and thinks i'm bent like pretzel
Anyone ever had this happen with a DG03 where it lost programmed gases?
Last edited: