Hi All,
Does anyone know how to set the time in an Apeks Quantum dive computer in the 24 hours format? I just replaced the battery of my dive computer, but could not reset the time in the 24 hours format that I preferred.
Thanks for any help.
Terry
Hi All,
Just saw the Suunto SK-8 released in the market recently. Has anyone compare its performance to the previous model SK-7?
Should I upgrade my SK-7 with the SK-8? Thanks for any of your input.
Terry
One of my student divers' Atomic Cobalt 2 dive computer seems having a problem of battery not holding its capacity.
First experience - after fully charged the battery to 100%, went out diving 2 days later, found the battery status was only 87%, made 2 dives, battery capacity dropped down to...
I have just stripped down my BM Tec Deep double tanks in order to go SM Tec Deep. For converting my OMS V101 double tank manifold into V103 and V103-L valves, I need two pieces of V112 end plug. Does anyone know where I can get these parts?
In addition, any source of a buttplate for my OMS...
I have two Atomic T2 regulators with four T2 second stages for quite a while. Over the years two front covers and three strain relief sleeves of the second stage cracked and became brittle.
Called Atomic Aquatics at 1-888-270-8595 one day while Ryan Kenney answered my phone. Explained to him my...
Recently I just installed a pair of Si Tech Permanent Cuff Rings on a drysuit using PB-300 glue. I found out PB-300 was very good for doing the job. My next project will be to install Si Tech Neck Tite Ring on the drysuit and I need more glue.
A tube of 4 ounce PB-300 cost me Cad$42 including...
Whites Fusion Bullet is my second drysuit after my custom made neoprene drysuit starts to leak through many pinholes due to age.
I am 5'10", 195 lbs. with 10.5" long and 4.5" wide feet. My neoprene drysuit came with a pair of very nice hard sole neoprene and rubber reinforced size 9 boots. I...
I am new to sidemount diving. I know Highland Tank Band is pretty good for the sidemount tanks. However I have seen people use perhaps 1" or 1.5" tank band which is probably better for traveling divers to check in their luggage.
I have also seen on the video, some sidemount divers seem use the...
I dive with both dry suit in cold water and wet suit in warm water. I am considering to retrofit my fins with stainless steel spring strap. I already have all the parts for the spring strap except the 10" spring for the dry suit diving and 8" spring for the wet suit diving.
Any help to get the...
I need to buy a couple Teledyne R-22D oxygen sensors for the Megalodon Rebreather. Could someone help me to locate a supplier with good price? Thanks for anyone who helps.
Best regards,
Terry
I am going to change latex neck seal and wrist seals on my dry suit in the near future(I have done it before). In order to make the job looks better, I hope I could get some heat activated seam sealing tape that Whites or Bare use to tape on their dry suits. Could someone help me to locate a...
Would you please offer me some information of what kind of glue to use for replacing a neck seal on Bare's Nexgen drysuit. Thank you very much for your help.
Best regards,
oldpeanut
My drysuit inflator valve (a Si Tech swivel intake valve) is now inflating itself without pushing the button. I am considering to service the valve myself.
Does anyone have the experience to work on a Si Tech inflator valve before? What kind of special tool is needed to disassemble the...
Does anyone know what kind of cement I should use for the Mobby's drysuit wrist seal replacement? It seems Mobby's drysuit has different type of waterproof coating on their fabric. Can I just use the regular latex seal contact cement? Please advise. Thanks a lot.
Regards,
Terry
Lately I just replaced my neoprene drysuit's neck and wrist seals with new latex seals. In order to reinforce the seam between latex seal and neoprene material, I would like to use thin rubber strip or stretchy nylon strip to tape on the seam.
Unfortunately I could not find any thin rubber...
Hi,
I have just joined Scuba Board today as a member. Although I have been diving since 1972 and logged more than 2300 dives so far, I found out there are a lot of things I can learn from the other members here.
I am a PADI insrtuctor currently residing in Vancouver, B.C. Canada. Before I...
Hi Everyone,
I am a new registered member. I have visited this board a few times and found out I could get some valuable information I need to know from the members here.
Is there anyone who has experience with pee valve for drysuit made by OMS and Halcyon? The price difference between...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.