Just repaired a blocked HP Auto drain on MCH16 that was used for 5 hours unknowingly with it not functioning... The filter was completely saturated with visable water droplets on filter cartridge.
However, after rebuilding the HP drain solenoid, we still get excess water in filter...
Things i've tried already:
*Cleaned Seperator,
*Checked auto drain timers,
*Ran tests on LP and HP auto drains - dumping ok,
*Pressure Maintenance Valve - Correctly set,
*Run comprssor for 10mins with all drains open.
The compressor is being run in a tropical climate, was recently overhauled and it is only excess water in the filter - not oil, and the air intake is adequate.
Any ideas anyone??
However, after rebuilding the HP drain solenoid, we still get excess water in filter...
Things i've tried already:
*Cleaned Seperator,
*Checked auto drain timers,
*Ran tests on LP and HP auto drains - dumping ok,
*Pressure Maintenance Valve - Correctly set,
*Run comprssor for 10mins with all drains open.
The compressor is being run in a tropical climate, was recently overhauled and it is only excess water in the filter - not oil, and the air intake is adequate.
Any ideas anyone??