Jens Bölte
Contributor
Hello
I have a MK20 1-stage here which I just serviced. The problem is that the IP is too high, around 11 - 11.5 bar, after service. I did not measure the IP before service. So, I can't tell how high it was before service. Any idea how I could get it down to 9.5 bar? Even removing all plastic rings (a white one and a black one sitting on each side of the spring) brought down the IP only to 11 bar. It is not an IP creep. IP just goes up to 11 bar and stays there.
Best wishes Jens
I have a MK20 1-stage here which I just serviced. The problem is that the IP is too high, around 11 - 11.5 bar, after service. I did not measure the IP before service. So, I can't tell how high it was before service. Any idea how I could get it down to 9.5 bar? Even removing all plastic rings (a white one and a black one sitting on each side of the spring) brought down the IP only to 11 bar. It is not an IP creep. IP just goes up to 11 bar and stays there.
Best wishes Jens