parrothead600
Contributor
I am using the XS Scuba 50# Deluxe lift bag (the one with the funnel-shaped inlet). I have 2 questions.
First: When I deploy this bag & inflate it with my exhaled bubbles or with my octo, it is about 1/2 full of water. Due to the funnel-shaped inlet, the air will not purge the water out the bottom. Is there any way to inflte this bag without getting so much water inside of it?
Second: After drying the bag, durring rolling it up for storage, I always seem to have quite a bit of air inside that I can't purge. I first roll it from bottom to top & pull the dump valve, then fold & roll it from top to bottom. But there is still some air inside that I can't get out. Are there any tricks to completely deflating this bag? I would like to get it as small as possible for storage in by BC pocket.
Thanks
First: When I deploy this bag & inflate it with my exhaled bubbles or with my octo, it is about 1/2 full of water. Due to the funnel-shaped inlet, the air will not purge the water out the bottom. Is there any way to inflte this bag without getting so much water inside of it?
Second: After drying the bag, durring rolling it up for storage, I always seem to have quite a bit of air inside that I can't purge. I first roll it from bottom to top & pull the dump valve, then fold & roll it from top to bottom. But there is still some air inside that I can't get out. Are there any tricks to completely deflating this bag? I would like to get it as small as possible for storage in by BC pocket.
Thanks