SaltyWombat
Contributor
I bought a kit of o-rings to service a power inflator. Getting the new o-rings on has been a challenge. I can't seem to get the small 006 o-rings installed on the small internal stem. I'm using a plastic pick, but I have a set of 3 brass picks I could try.
I have 2 bullets for installing o-rings on LP and HP hoses. Those are great. Are there similar ones for power inflators? Or, is there a tool I should use besides a plastic pick?
Any tips welcomed.
I have 2 bullets for installing o-rings on LP and HP hoses. Those are great. Are there similar ones for power inflators? Or, is there a tool I should use besides a plastic pick?
Any tips welcomed.