sambolino44
Contributor
How can I find out what size of O-rings go in the universal swivel on my LP hose? It's marked "OmniSwivel International".
O-rings for LP hose swivels
- Thread starter sambolino44
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
HenrikBP
Contributor
Can't tell you specifically, but from what I've been able to dig out it could be a -010 o-ring:
http://www.scubaboard.com/forums/repairing-your-own-gear/310236-diy-save-dive-o-ring-kit.html
If you remove the o-ring - gently - you may be able to get approximate ID and OD measurements and can compare with o-ring specs.
Henrik
http://www.scubaboard.com/forums/repairing-your-own-gear/310236-diy-save-dive-o-ring-kit.html
If you remove the o-ring - gently - you may be able to get approximate ID and OD measurements and can compare with o-ring specs.
Henrik
R
redacted
Guest
Most hoses use a 2-010 at the 2nd stage connection. Scubapro uses an oddball o-ring on their superflow hose which I replace with a 7mm OD x 1.5 MM wide that appears to be a bit large but works OK.
Similar threads
