Olympus EM-1 Won’t Turn On

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Randallr

Contributor
Messages
163
Reaction score
111
Location
New York, NY
# of dives
200 - 499
Anyone else experiencing this? I’m shooting with an EM-1 Mark 1 in Nauticam housing, no problems until this year. On some dives, the camera simply won’t turn on - black screen, as if the battery is dead. But the battery is fully charged - and I always test the connections and everything else before I dive. Taking the battery out and putting it back in fixes the issue - but that’s not really feasible underwater (especially on a shore dive).

Today’s dive was even weirder. I’d tested the camera and strobes in the housing pre-dive, and everything went swimmingly. But in the water, I got just the dead screen. An hour later, on land, the camera turned on fine. I’m wondering if there’s some issues with sudden temperature changes, or perhaps moisture in the battery compartment. Maybe a glitch when the camera auto-shuts down. Anyone have any reality checks here? I updated the firmware, but it didn’t solve the problem.
 
Could be a number of things. Is it only with one lens?, I had an issue with the micro switch in the locking pin, one particular lens when mounted would result in a blank screen, jiggling the lens would sometimes get it to work, other lenses were fine. I think that lens had a slightly different depth of the hole in lens flange so the pin didn't seat fully. I think it was stuck in a state between no lens and mounted lens. Fix was quite cheap at Olympus repair centre. It was diagnosed by seeing if mounting a different lens restores things.
 
Try and recreate the fault outside the housing, if you hold down any buttons and try using the camera does the same issue happen? Could be a weak spring depressing a button?
 
I had the exact same issue several times and after extensive testing it appears that some SD cards cause the problem. Since switching to use only high speed (meaning expensive) name brand (Sandisk and ProGrade) cards the problem has not occurred again, but switching back to some no-name cards often has the problem.

Bill
 
If the camera ALWAYS works out of the housing, but fails IN the housing, I'd suspect some button possibly getting sticky, pushing on a control, and messing things up. Try the suggestion of @chris kippax.
 
In my case the problem happened in the water, but continued to not work when taken out of the housing. I could reproduce it on land.
Bill
 
Check the end of the ON/OFF housing button actuator arm which contacts the switch on the camera. If there is a pad it may have shifted or even fallen off. If the actuator mechanism is articulated there may have been some sort of shift resulting in the arm missing the button. Also, mentioned above, check the positioning pads for the camera body inside the housing. Cleaning the battery and camera housing contacts with electrical contact cleaner might be another possibility.
 
It could be from over time moisture has gotten in and corroded some contacts. I like the Idea of cleaning them.
 
https://www.shearwater.com/products/teric/

Back
Top Bottom