vixtor
Contributor
I have also sent a message to Shearwater's support, but I thought to ask here in case somebody else noticed this.
After updating my unit to V34, I have noticed that the ascent speed indicator is not working correctly anymore. The unit is used in OC/Tec mode, in Metric. Knowing they made a change to the units (to have temperature as an independent setting) I am thinking this could be related to the change in somehow.
Anyway, during my last 2 dives (with the new V34) I have noticed that during the ascent I was seeing no white arrow (as I did in the past). I have increased my ascent speed, and right around ~9-10m/min (as shown by my backup Vyper Air) I got a full stack of 6 white arrows. Increasing the speed more I got a full stack of 6 yellow arrows. In the past, 1-3 arrows were white, 4-5 were yellow and 6 arrows would have been red (and I didn't had the speed for red anyway).
If the ascent was slow (like 3-6m/min) I was getting no arrow on the display.
Have you noticed the same behaviour? If not (and you use imperial) could you switch to metric and see if you can confirm it?
Do you know if there's any way to downgrade to V33 until the issue is fixed?
After updating my unit to V34, I have noticed that the ascent speed indicator is not working correctly anymore. The unit is used in OC/Tec mode, in Metric. Knowing they made a change to the units (to have temperature as an independent setting) I am thinking this could be related to the change in somehow.
Anyway, during my last 2 dives (with the new V34) I have noticed that during the ascent I was seeing no white arrow (as I did in the past). I have increased my ascent speed, and right around ~9-10m/min (as shown by my backup Vyper Air) I got a full stack of 6 white arrows. Increasing the speed more I got a full stack of 6 yellow arrows. In the past, 1-3 arrows were white, 4-5 were yellow and 6 arrows would have been red (and I didn't had the speed for red anyway).
If the ascent was slow (like 3-6m/min) I was getting no arrow on the display.
Have you noticed the same behaviour? If not (and you use imperial) could you switch to metric and see if you can confirm it?
Do you know if there's any way to downgrade to V33 until the issue is fixed?