АлександрД
Contributor
once I bought Sea&Sea YS-27 and had look for cable for it...
special cables had stupid price around 60$ per small piece of plastic....
I take:
Digital Optical Fiber Audio Cable SPDIF Toslink (price could be from 2-4$)
Heat Shrink tubeS (price for set of different diameters is around 1-2$)
knife (I had)
Lighter or Hot air solderer
Cut optical cable to the desired lenght (cut away connectors anyway)
Put on thinest tube, with length 2-4 cm (1/2 till 1 inch), heating it.
Than more thick, and shorter. Heat it.
etc.
at final steps:
Cool it well, than cut front edge with sharp knife.
Heat it again, and then push it in-to connecting hole and bent over, to fit exact size.
Also can bent hot cable.
Wait untill it be cold, and use and be happy
If you got bad selfmade connector - just cut away, and repeat
It takes around half an hour, no more, to build it.
special cables had stupid price around 60$ per small piece of plastic....
I take:
Digital Optical Fiber Audio Cable SPDIF Toslink (price could be from 2-4$)
Heat Shrink tubeS (price for set of different diameters is around 1-2$)
knife (I had)
Lighter or Hot air solderer
Cut optical cable to the desired lenght (cut away connectors anyway)
Put on thinest tube, with length 2-4 cm (1/2 till 1 inch), heating it.
Than more thick, and shorter. Heat it.
etc.
at final steps:
Cool it well, than cut front edge with sharp knife.
Heat it again, and then push it in-to connecting hole and bent over, to fit exact size.
Also can bent hot cable.
Wait untill it be cold, and use and be happy
If you got bad selfmade connector - just cut away, and repeat
It takes around half an hour, no more, to build it.