SlugLife
Contributor
I would like to have quick-disconnects between the 1st stage & the LP hoses. I have several octos I'd like to setup this way, making it possible to remove or swap both the inflator hose & backup 2nd stage regulator. I'd like to do this to a number of octos, if I can get the cost per fitting down enough.
If I'm understanding correctly, I'd need a 3/8-24 threads to Quick-Disconnect on the 1st stage side, then Quick-Connect to 3/8-24 threads?
If I'm understanding correctly, I'd need a 3/8-24 threads to Quick-Disconnect on the 1st stage side, then Quick-Connect to 3/8-24 threads?
- What size of fittings should be used? (Does anyone have a good scuba-fittings guide?)
- Should I be careful to ensure the female side of the quick-disconnect is one way and auto-closes? Or are they usually that way by default? For example, if swapping a 2nd stage regulator underwater (not that I expect to do that in the near future).
- What's the difference between "locking" and "non locking"
- Direct links where you can pick up the correct fittings inexpensively or in bulks are also appreciated.