Dale Lusby
New
I am about to get a few sets of Conshelf XIV regulator sets back in service and wanted to see if the best option to service them is to purchase kits from a source like vintagedoublehose.com or is there a better way to go about it like getting the o-rings from other sources in essence making my own service kit. I did see a thread which identifies most of the o-rings. I'm not too concerned with my ability to service them and don't mind spending the money ($42 or so per 1st and 2nd stage set for kit) although if there is a less expensive way to go I'm all ears. I assume there are a few parts in the kits that aren't as simple to place as o-rings but perhaps I'm wrong.
Here are the two kits I found at vintagedoublehose.com for the XIV. Should I expect to need too much more assuming hoses and mouthpieces check out? Anyone with experience on these kits?
Store - Vintage Double Hose
Store - Vintage Double Hose
I learned to dive 23 years ago on these regs and instead of spending money on new ones I'd like to use them again.
Here are the two kits I found at vintagedoublehose.com for the XIV. Should I expect to need too much more assuming hoses and mouthpieces check out? Anyone with experience on these kits?
Store - Vintage Double Hose
Store - Vintage Double Hose
I learned to dive 23 years ago on these regs and instead of spending money on new ones I'd like to use them again.