stano
Contributor
So my buddy and I are looking into a few issues on his DPV. We are changing the o rings between the motor portion and the middle ring section. We have it all torn apart and it was going pretty well. We can't however figure out how to remove the motor. This scooter had obviously leaked in the past and we want to get it all apart and clean everything up. We have removed the prop, shaft seal on the bottom end and have the motor exposed on the top end. There is a snap ring visible from the prop side but I am having a hard time believing that this holds the motor in place. We can't see any other fasteners that might hold the motor in place. So if anyone who has done this would care to offer any advice it would be greatly appreciated.
Thanks
Stano
Thanks
Stano