I was wondering how you use your Petrel for deco stop dives?
Are you:
1. Cutting tables with deco software then setting your Petrel in Technical mode and just following Run Times? (backup tables on slate)
2. Cutting tables with deco software then setting your Petrel to Gauge mode? (tables on slate)
3. Using the onboard dive planner and then following the plan in Technical mode or Gauge mode? (plan generated from Petrel on slate)
4. Not pre-planning the dive or cutting tables and just reading the Petrel on the fly?
5. Other?
Rather than set this up as a poll I wanted to get a little more detailed info on how you're conducting your dives with your computer.
Thanks.
Are you:
1. Cutting tables with deco software then setting your Petrel in Technical mode and just following Run Times? (backup tables on slate)
2. Cutting tables with deco software then setting your Petrel to Gauge mode? (tables on slate)
3. Using the onboard dive planner and then following the plan in Technical mode or Gauge mode? (plan generated from Petrel on slate)
4. Not pre-planning the dive or cutting tables and just reading the Petrel on the fly?
5. Other?
Rather than set this up as a poll I wanted to get a little more detailed info on how you're conducting your dives with your computer.
Thanks.