View attachment 153456I didn't see a manual for the open water version
...but seriously though, is the the top node too high?
ok, so I hope that you finally figured out that your BC is upside down
Setup of a BC is fairly simple, BC has four, two lower and two located more on top of BC points where you attach the bungees.
The bottom, lower located ones are meant for recreational divers as inflated wing will be bigger - more sticking out of diver body.
Higher ones located on top of BC attachment points will keep even fully inflated BC flat, compact and close to diver body.
There is quite few methods that Stealth's users applied in terms of BC mounted bungees but I agree with proposed by xDeep way to keep bolt snaps / double enders
on one side of BC (short loop / connection) and other ends longer. Its very useful to tie one, two knots on these ends so you can easily adjust the tension of bungees
for example diving drysuit one day and wetsuit other one.
Please take a look at attached few pictures that will show you proper method of mounting the BC with its components on a diver.
There is few really good ideas for mounting for example argon bottle or light on the back.
I have tried light mounted on my back underneath the wing and like it so much that it became my standard setup.
Let me know if you have any questions, will try to answer with pictures and other.