My Perdix AI was working ok - including showing the transmitter pressure - but the firmware was outdated. The firmware update seemed to go fine, but afterwards the tank pressure no longer shows up on the main screen. Also, there's no flashing "NO COMMS" message when it's not in range of the transmitter. I know it's not the transmitter, since (1) it worked 30 min ago and (2) my backup PDC (not a Shearwater) continues to read the pressure. Obviously I'm not in the water, yet.
I'm leaving for the Red Sea in about 45 hours and I REALLY want to have AI working again on the Perdix.
I'm hoping I'm just doing something stupid and haven't set the display to show the pressure, or something similar. Under System Setup -> AI Setup it shows "AI Mode On", Units "PSI", "TX Setup" T1, and "GTR Mode" T1. T1 is set to the correct serial #. I'm wary about hitting "unpair", and starting fresh, since I don't want to make things worse.
I put in a support request on the Shearwater Website, but am hoping someone here knows what I'm doing wrong.
Thanks.
Don Berry
I'm leaving for the Red Sea in about 45 hours and I REALLY want to have AI working again on the Perdix.
I'm hoping I'm just doing something stupid and haven't set the display to show the pressure, or something similar. Under System Setup -> AI Setup it shows "AI Mode On", Units "PSI", "TX Setup" T1, and "GTR Mode" T1. T1 is set to the correct serial #. I'm wary about hitting "unpair", and starting fresh, since I don't want to make things worse.
I put in a support request on the Shearwater Website, but am hoping someone here knows what I'm doing wrong.
Thanks.
Don Berry