buton
Contributor
i am at coz and my camera got flooded today...
for what i see is that the locking mechanism is not putting enough pressure to close the lid.
i cleaned the oring and put grease again and i tested on a bucket and it is still leaking from that corner..
after looking at the pictures(right side the gap is bigger than the left), do you think i can get my xz-1 replaced, obviously this is a manufacturing issue, since it leaked again after cleaning the oring and making sure it wasn't my fault.
for what i see is that the locking mechanism is not putting enough pressure to close the lid.
i cleaned the oring and put grease again and i tested on a bucket and it is still leaking from that corner..
after looking at the pictures(right side the gap is bigger than the left), do you think i can get my xz-1 replaced, obviously this is a manufacturing issue, since it leaked again after cleaning the oring and making sure it wasn't my fault.