galodoido
Contributor
I am always careful to use two wrenches when replacing the hose in the second stage, but this time the inlet fitting ("second stage nut") got slightly unscrewed when I was tightening the hose fitting in the second stage.
I just went ahead and tightened it back into where I thought it was. Anybody see any potential issues if somehow I didn't manage to tighten it back to where it was?
I believe I was able to reverse what I did and I tried to unscrew it with my hand just to be sure and it looks pretty snug in there. I tested the regulator and it has no leaks and is breathing fine.
Any feedback is appreciated. Thanks!
I just went ahead and tightened it back into where I thought it was. Anybody see any potential issues if somehow I didn't manage to tighten it back to where it was?
I believe I was able to reverse what I did and I tried to unscrew it with my hand just to be sure and it looks pretty snug in there. I tested the regulator and it has no leaks and is breathing fine.
Any feedback is appreciated. Thanks!