Diy digicam tray

[Spoon]

anyone have any plans on making an improvised camera tray with side handles/grips? i wanna experiment and was looking of making an aluminum base and some anodized handles. if only i had some plans

 

[Couv]

Bumping this as I have the same question.

 

[Akimbo]

Mako's Two Handle Transformer Camera Tray has some clever features that you might find inspiring. I have no idea if it could be used in your application, but the price could make it a great starting point.

 

[biggpa]

I have made my own camera tray, but out of (various) plastics, no AL

Bottom tray made out of a cheap cutting board
Handles: 1/2" x 5" PVC, 5/8" x 1/4" x 3/4" Nylon Spacer (placed inside the PVC), bicycle grips from amazon, threaded rod, various nuts, locline base
Place the nylon spacers inside the PVC. This will have a hole in the center for the threaded rod
Cut the "tops" off the bike grips
Slip the bike grips on the PVC

I don't abuse it, but it has been solid since I made it in Nov 2012. Maybe that will be helpful

 

[JohnnyC]

Check out Snake River Prototyping's tray. It's the best I've found. You can try and replicate one of those.

Thanks to @tursiops for catching my screw up!

 

[tursiops]

Check out Salt River Prototyping's tray. It's the best I've found. You can try and replicate one of those.

Snake River.....