Jonno
Registered
Dear All,
Recently overhauled Alkin W32
This has had new valves and rings in all stages.
After recommissioning ran for about an hour then the 8 bar safety valve at the end of the intercooler from the first stage (ie beforethe second stage inlet) started operating.
Changed valve, same problem
Spoke to Alkin theys said dirty valve. Don't have tool for the inlet but blew air through easily from low pressure system. Stripped outlet valve, small about of gasket debris which could have, in theory, been jamming the outlet valve. Ran ok for 30 mins then same problem. Ran with outlet disconnected no problem but then again there is no back pressure.
Only thing I have not done is the inlet valve which I will need to fashion a tool for, before I do that are there any suggestions please?
Recently overhauled Alkin W32
This has had new valves and rings in all stages.
After recommissioning ran for about an hour then the 8 bar safety valve at the end of the intercooler from the first stage (ie beforethe second stage inlet) started operating.
Changed valve, same problem
Spoke to Alkin theys said dirty valve. Don't have tool for the inlet but blew air through easily from low pressure system. Stripped outlet valve, small about of gasket debris which could have, in theory, been jamming the outlet valve. Ran ok for 30 mins then same problem. Ran with outlet disconnected no problem but then again there is no back pressure.
Only thing I have not done is the inlet valve which I will need to fashion a tool for, before I do that are there any suggestions please?