Marty Bess
Contributor
I'm setting up a redundant high-pressure gauge on an Aqualung Mikron, which has two high-pressure ports.
First question: I ordered this guage on Amazon that looks to have the HP Swivel Pin in it. Will I need anything other than an HP hose to add this to my Mikron?
Second question: I replacing the o-ring in my Aqualung transmitter and if you scroll down to the bottom of that hyperlinked page for the transmitter it says the o-right is a "The High Pressure o-ring located at the base of the transmitter is Size AS568-012, Viton™ material while the battery cap o-ring used is Size AS568-016, Nitrile (Buna-N) A70". Does anyone know if these are just the standard o-rings for "yoke", (not DIN) tanks?
Thanks
Marty
First question: I ordered this guage on Amazon that looks to have the HP Swivel Pin in it. Will I need anything other than an HP hose to add this to my Mikron?
Second question: I replacing the o-ring in my Aqualung transmitter and if you scroll down to the bottom of that hyperlinked page for the transmitter it says the o-right is a "The High Pressure o-ring located at the base of the transmitter is Size AS568-012, Viton™ material while the battery cap o-ring used is Size AS568-016, Nitrile (Buna-N) A70". Does anyone know if these are just the standard o-rings for "yoke", (not DIN) tanks?
Thanks
Marty