I saw similar discussions, but I would like to open a new one in case something has changed in the meanwhile
I have a Scubapro X-One BCD. My accessories configuration is the following:
1) DSMB --> left pocket
2) Spool --> right pocket
3) Suunto Computer --> left wrist
4) Compass (optional) --> right wrist
5) Roll-up snorkel --> right pocket or clipped to BCD (upper left D-Ring)
6) Torch: clipped to BDC D ring (upper left D-Ring)
7) Go pro + Pole: base of the pole clipped to BCD (lower right D-ring) Go pro tied when not in use in a lanyard clipped to BCD (lower left D-ring)
8) Porcelain Line Cutter: sheath tied up to BCD
I noticed that for technical diving instructions on where to put accessories are very precise, almost standardized. While there are many configurations for recreational diving, especialy with jacket BCD
I have a Scubapro X-One BCD. My accessories configuration is the following:
1) DSMB --> left pocket
2) Spool --> right pocket
3) Suunto Computer --> left wrist
4) Compass (optional) --> right wrist
5) Roll-up snorkel --> right pocket or clipped to BCD (upper left D-Ring)
6) Torch: clipped to BDC D ring (upper left D-Ring)
7) Go pro + Pole: base of the pole clipped to BCD (lower right D-ring) Go pro tied when not in use in a lanyard clipped to BCD (lower left D-ring)
8) Porcelain Line Cutter: sheath tied up to BCD
I noticed that for technical diving instructions on where to put accessories are very precise, almost standardized. While there are many configurations for recreational diving, especialy with jacket BCD