so, I recently got a new analox analyser...was super excited...in my excitement...I plugged the sensor into the cable before I screwed it in...immediately realizing my error...I went to unplug it so I could screw it in...long story short, in my zeal...I pulled a cable out of the connector...FML....yes yes, I know, dont pull on the cable to get the connector out...should of known better
anyways, question is...does anyone know what kind of connector / crimper I need to fix this? I need a new connector that goes into the oxygen sensor, and the crimping tool to make a new one I think...
I tried reaching out to the manufacturer...they have yet to respond back
thanks for any help you can offer
anyways, question is...does anyone know what kind of connector / crimper I need to fix this? I need a new connector that goes into the oxygen sensor, and the crimping tool to make a new one I think...
I tried reaching out to the manufacturer...they have yet to respond back
thanks for any help you can offer