Hello,
I recently bought a second hand Faber tank and it came with a SOS (San-O-Sub) valve that I am pretty sure uses the service kit shown below:
Does anybody know the dimensions of the copper ring and the small o-ring (bottom right one in the image above)?? The o-ring is the one that goes around the stem.
I want to see if I can get them easily in local market before I make the decision to open/inspect/clean the valve. Basically I need the copper ring to ensure that I can close again the valve. The o-ring will be nice to have too just in case.
Thanks
I recently bought a second hand Faber tank and it came with a SOS (San-O-Sub) valve that I am pretty sure uses the service kit shown below:
Does anybody know the dimensions of the copper ring and the small o-ring (bottom right one in the image above)?? The o-ring is the one that goes around the stem.
I want to see if I can get them easily in local market before I make the decision to open/inspect/clean the valve. Basically I need the copper ring to ensure that I can close again the valve. The o-ring will be nice to have too just in case.
Thanks