SP G250 jam nut

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

There is a "tool library" here that may get a significant donation.
 
@couv The point-to-point dimension on my nut is 0.7860". This will clear the exhaust tee. However, I couldn't slip a 0.010 feeler gauge between the nut and tee. You **MIGHT** be able to slip a 0.005 but it would be very close.

IMG_2372.jpg
IMG_2378.jpg
 
OK let's start a list from scratch. Standard G250 316 stainless steel:

Couv..............4 please
rsingler..........10
1967Goat........8
Modi..............12
buddhasummer.......4
 
Read the whole :censored: post...
 
The largest feeler gauge I can slip between the nut and the exhaust tee is .018". So, you could go .036" larger (.018 each side of the nut). This leaves very little margin for error though. I would stick with .743", which leaves a few thousandths for a 3/4" (.750) wrench. My .02.
WTF, you left me off???? :rant:
OK Bob is in charge of the list from now on. lol
 
https://www.shearwater.com/products/teric/

Back
Top Bottom