[w/ Update]Reg serviced at scubatoys. But reg still freeflows, and SPG is flooded after 1st dive

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

But Scubapro's service manual has (IMO) an error in the tuning instructions which causes exactly this problem:
they advise having the lever in contact with the diaphragm for optimal tuning. But when you screw on the face plate, the thrust washer's inner diameter squeezes the diaphragm ever so slightly, and the lever gets a tiny bit of pressure. Tightening the poppet spring then won't fix it, because the lever has lifted the poppet off the seat ever so slightly. That's enough to produce exactly this problem.
Instead, the technician should leave a 0.25mm gap between lever and diaphragm when the reg is pressurized.
But a young technician following the factory directions without understanding how the center balance mechanism works won't know how to fix it.

D420 repair manual-modified
 
I'll reply to each of your points:
1. This is not unusual, as long as the SPG doesn't actually spin off, it's fine. The only seals are the 2 spool o-rings.
2-3. Also not unusual, but typically on a brand new one you can just pull it out with your fingers.
4. This is the problem, it indicates that the inward spool o-ring was not installed correctly on the spool. But if that o-ring was not in place, there should have been a very noticeable air leak. Lots of bubbles.
5-6. It's normal for there to water on the exterior of the spool between the o-rings, and on the threads. There's usually no o-ring sealing those.

The issue is that if there is a leak that could allow water in to the SPG, that same leak would let air out when it's under pressure, and considering it's full tank pressure, I'm sure you can understand the amount of tiny bubbles we are talking about. Nobody paying even the slightest bit of attention would miss that.

I assume the SPG was working, correct? IE, during the dive it showed tank pressure gradually decreasing throughout the dive? If that was the case, and there was no loud air leak, then the only possibility is that water got in when you rinsed your reg. The only way I can imagine that happening, that sort of jibes with your description, is that the inner o-ring was not installed on the spool, but instead pushed into the SPG. Then when the reg was pressurized it somehow sealed air against the end of the spool, i.e. the air pressure pushed it into place in such a way that it sealed under pressure, but relaxed enough when the pressure was released to allow water into the SPG during a rinse.

I have to say that this explanation is just a wild guess and is probably a long shot. And considering you only had your reg in the rinse tank for a few moments, even if it were true (which I kind of doubt) then there shouldn't have been much water. How much came out, a few drops?

I would try to blow some dry air into the SPG, maybe using a can of compressed air and one of those plastic straws. See how much actually comes out. I bet you can dry it out and it will work fine.
Or, if you have another set of regulators, and a blow-gun which has the right adapter for your BCD, just use your scuba-tanks.

I have a compressor, but find I usually just use my scuba-tanks instead.
 
https://www.shearwater.com/products/swift/

Back
Top Bottom