darthcoker
Contributor
Greetings
1) Some of our team AGAs are starting to free flow (these are fairly old units, but pretty well maintained).
I have tried just about everything to fix the problem - new parts, adjusting the valve insert, etc.
Even when I get one working on the surface in the work room - as soon as it get back in water - off it goes again.
2) Also, the lever assemblies (the small lever on outside of the reg. housing) frequently wont shut off - the lever keeps popping back open. Have replaced all the internal parts - with the exception of the Valve Housing. I suspect the small notch in the housing is worn and will no longer "capture" the lever nipple.
Have spoke with Interspiro and so far their suggestions are not working.
Does any one have any recommendations on these 2 problems?
SC
darthcoker@yahoo.com
1) Some of our team AGAs are starting to free flow (these are fairly old units, but pretty well maintained).
I have tried just about everything to fix the problem - new parts, adjusting the valve insert, etc.
Even when I get one working on the surface in the work room - as soon as it get back in water - off it goes again.
2) Also, the lever assemblies (the small lever on outside of the reg. housing) frequently wont shut off - the lever keeps popping back open. Have replaced all the internal parts - with the exception of the Valve Housing. I suspect the small notch in the housing is worn and will no longer "capture" the lever nipple.
Have spoke with Interspiro and so far their suggestions are not working.
Does any one have any recommendations on these 2 problems?
SC
darthcoker@yahoo.com