CCR Color Blindness Considerations

[MrBlenny]

What was your set point?

IIRC it was .7 since we were in 5ft of water. Low PPO2 warning was .4 I was also trying to keep the loop volume low since my buoyancy was already a mess, but I suspect that is why it dropped down so low. Again, I'm not even SB MOD1 certified yet Also, set-points were already there and I didn't change anything.

 

[grantctobin]

What was your set point?

Not a relevant question right? Have you passed your open water yet?

 

[Jack Hammer]

As a side note the Shearwater HUD has a color blindness mode too (normally too high or too low both flash red).

 

[Alaskan Scuba Dude]

Not a relevant question right? Have you passed your open water yet?

Not a relevant question.

 

[211ratsbud]

I use color blind mode in the SW hud. I only get the control pallette on the Ishihara test and squeak by the falant test.

My suggestion is to get life support equipment that supports your condition.

Other than that Ive tweaked the SW handset stuff to give me proper contrast.

It's unfortunate but some devices will be ruled out.