SunkenSeeker
New
About 6 months ago I bought a 2y old used/refurbished Canon 40D Ikelite housing. Last week during a dive I notices what seemd to be a hairline crack comming from the upper right corner going to the shutter release handle.
Checking it above water, it seems the line is on both the outside and the inside, but doesn't seem to go all through the housing. No leakages dureing the dive either.
Can this be a molding issue (in that case I'm surprised I didn't notice it before) can this be the start of some serious issue?
BTW I found one on the lower left corner as well, but this one was only on one side and about 1/4" long.
regards,
Ferry
Checking it above water, it seems the line is on both the outside and the inside, but doesn't seem to go all through the housing. No leakages dureing the dive either.
Can this be a molding issue (in that case I'm surprised I didn't notice it before) can this be the start of some serious issue?
BTW I found one on the lower left corner as well, but this one was only on one side and about 1/4" long.
regards,
Ferry