Inflator connection to divesoft analyzer

[Matan]

I understand one can purchase the following parts:

+

+ some surgical tubing - to be able to connect from inflator hose into divesoft analyzer.

I'm just not sure which tubing to get? anyone knows the diameter of the divesoft input?


Thank you,
Matan.

 

[Rich1280]

Divesoft sell a hose with the correct diameter for a few Euros, but I just used some oxygen tubing from an old O2 mask, then a wrap of electrical tape made it the right size to fit the hole on the Solo analyser.

The one we have was direct from Divesoft and is a single piece, and does not require assembly. I just warmed the oxygen pipe in water and slid it over the other end of the nozzle.

https://eshop.divesoft.com/gn/flow-limiter-for-an-inflator/1591

Their pipe too instead:

https://eshop.divesoft.com/gn/analyzers-he-o2/connection-hose/8009

I find this a super bit of kit for easy analysis on the JJ when I run pre dive checks.
Hope that helps,
Rich

 

[Manatee Diver]

Divesoft has an adapter that they sell, you just slip it onto the tubing that they provide/sell.

 

[Matan]

I know they have it - the cost if that + shipping is more than twice compared to buying those parts on eBay.

Matan.