We have lots of military vehicles including Tanks and artillery guns in Libya that are damaged beyond repair and are no longer usable sitting as wreckage on streets and military bases (lots of Tanks). I'd like to try to sink them in 10 - 15 meter waters in the sandy patches close to shore. I need advice on what I will have to remove from these vehicles as not to create environmental issues in the water or cause danger to marine life and/or divers after sinking.
I am going to make sure that all fluids, grease, batteries, fluid pipes/lines, asbestos (if any), wires and anything else I believe is a pollution hazard are removed before sinking.
Any other material or parts I should remove from these vehicles to prevent pollution and/or danger to marine or divers life?
(In addition to the advice on what what else to remove from these vehicles, I'd appreciate any other advice on this project that I haven't addressed above please)
I am going to make sure that all fluids, grease, batteries, fluid pipes/lines, asbestos (if any), wires and anything else I believe is a pollution hazard are removed before sinking.
Any other material or parts I should remove from these vehicles to prevent pollution and/or danger to marine or divers life?
(In addition to the advice on what what else to remove from these vehicles, I'd appreciate any other advice on this project that I haven't addressed above please)
Last edited: