I have a Mares Axis Pro octo and MR12 reg set. The high-pressure hose developed a leak at the fitting and I need to replace it. I think it failed because it was a little too short at 32" and a 36" would be better.
Where can I buy a quality hose online? I think it's 7/16" which I believe is the standard, correct?
Also, on the console end, how do I remove the PSI guage to get to the connector? I think the rubber console fixture can be "peeled" back to push the PSI guage out and gain access to the fitting but I'm not sure and I don't want to do more harm than good.
While I'm at it, I am going to replace the 2nd stage hose that supplies my main reg. It has developed a pretty major "kink" just past the hose protector (lot of good that did) and it seems like a reasonable idea to replace it before it fails.
Thanks for any help.
Where can I buy a quality hose online? I think it's 7/16" which I believe is the standard, correct?
Also, on the console end, how do I remove the PSI guage to get to the connector? I think the rubber console fixture can be "peeled" back to push the PSI guage out and gain access to the fitting but I'm not sure and I don't want to do more harm than good.
While I'm at it, I am going to replace the 2nd stage hose that supplies my main reg. It has developed a pretty major "kink" just past the hose protector (lot of good that did) and it seems like a reasonable idea to replace it before it fails.
Thanks for any help.