Raystafarian
Registered
I had some blades that rusted pretty good in my Eezycut trilobites about a year back, I ended up replacing the blades and being sure to do a thorough rinse and dry after dives, but the new blades are showing rust near the body (and in the body) where the rust was/is. I've tried cleaning the (is it plastic?) with baking soda and then vinegar with toothbrushes, but I haven't soaked the bodies trying to clean it off.
How should I try to clean these? If I soak the tool in vinegar am I likely to damage it? I don't want to try to remove the rust, end up with pitting and then have the blades end up being loose in the tool.
How should I try to clean these? If I soak the tool in vinegar am I likely to damage it? I don't want to try to remove the rust, end up with pitting and then have the blades end up being loose in the tool.