Caveeagle
Contributor
I have finally made the big switch over to diving dry. My first big challenge it that the Florida heat creates quite a bit of dampness in the suit from perspiration. Not a huge issue during the Dive, but I find my suit is not drying out as quick as I would like, and I hate to lay an expensive suit out In the sun to dry.
I found a couple threads on DIY drying racks, but they are too old for SB to allow me to post onto.
My first question is what size blower motor is best? I have seen a couple online. Is 55 CFM going to do the job?
FWIW, I am planning a hanging device that has sort of a pvc hangar extending into the sleeves, with flexible extensions that go down to each leg. I know I will have to experiment with restricting flow into the sleeves to make sure good flow to the legs.
Another idea is to ceiling or wal mount the blower motor with a timer switch, and just use a rubber union to attach the tubes when it's all hooked up.
I found a couple threads on DIY drying racks, but they are too old for SB to allow me to post onto.
My first question is what size blower motor is best? I have seen a couple online. Is 55 CFM going to do the job?
FWIW, I am planning a hanging device that has sort of a pvc hangar extending into the sleeves, with flexible extensions that go down to each leg. I know I will have to experiment with restricting flow into the sleeves to make sure good flow to the legs.
Another idea is to ceiling or wal mount the blower motor with a timer switch, and just use a rubber union to attach the tubes when it's all hooked up.