I have an Aeris Epic Computer that is about 5 months old with roughly 100 dives on it. About 30 of those are in the pool no deeper than 10 feet.
I had no problems at all for the first 4 months, but since then I have had several. At first the computer indicated that the battery was low (seemed early to be replacing it) and after a couple dives with it showing low I replaced the battery with the spare that came with the computer. I removed the back of the computer with the supplied tool, replaced the battery, checked the O-ring for wear (it was pristine) reapplied silicone grease and put it back together.
The computer functioned normally for 3 dives then stopped in the middle of the dive. The screen went blank, no warning or anything. I pressed several buttons while underwater and the screen came back on. After a few seconds it registered the transmitter as well and I finished the dive. After this dive I took the back off the computer again to see if water had gotten in or something. There were no issues I could see and the battery was not registering as low so I put the computer back together.
Since then it has turned off twice and the light has stopped working one other time. I ordered a replacement battery and replaced it and the O-ring just to be on the safe side and am still having the same issues.
Anyone else had similar problems? I have not lost any dive data so they aren't complete crashes. Even when the computer stopped in the middle of the dive it appeared to log the entire dive correctly. I would chalk it up to just display issues, but the mode will change as well.
I had no problems at all for the first 4 months, but since then I have had several. At first the computer indicated that the battery was low (seemed early to be replacing it) and after a couple dives with it showing low I replaced the battery with the spare that came with the computer. I removed the back of the computer with the supplied tool, replaced the battery, checked the O-ring for wear (it was pristine) reapplied silicone grease and put it back together.
The computer functioned normally for 3 dives then stopped in the middle of the dive. The screen went blank, no warning or anything. I pressed several buttons while underwater and the screen came back on. After a few seconds it registered the transmitter as well and I finished the dive. After this dive I took the back off the computer again to see if water had gotten in or something. There were no issues I could see and the battery was not registering as low so I put the computer back together.
Since then it has turned off twice and the light has stopped working one other time. I ordered a replacement battery and replaced it and the O-ring just to be on the safe side and am still having the same issues.
Anyone else had similar problems? I have not lost any dive data so they aren't complete crashes. Even when the computer stopped in the middle of the dive it appeared to log the entire dive correctly. I would chalk it up to just display issues, but the mode will change as well.