Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
Will do. Holding breath.View attachment 62429
I've tried the interface cord the logical way with the Sherwood Scuba label up. (Oriented to the computer screen), and down but neither seems to get through. Interface found... I hit ">" (go). It says, handshake... timeout.
I think I held my breath too long... I've suffered dain bramage.
I now can run the software without error messages but I cannot complete the handshake with the DC. I've tried the interface cord the logical way with the Sherwood Scuba label up. (Oriented to the computer screen), and down but neither seems to get through. Interface found... I hit ">" (go). It says, handshake....timeout. It was easier to do the firemans carry with my overweight buddy...(not easy)....(almost not possible) than it has been to get this going. (whaaa!)
After you uninstalled and reinstalled the driver, the first time you plugged the interface cable in your computer should have gone through a device recognition routine - did that happen?
Check your Device Manager, under Universal Serial Bus controllers you should have a listing for "2002 Design Inc. USB Download Device".
Label goes up. I sometimes have to shift mine radially one way or the other to get a full connection. Easier to show than to write, but it's kind of like using the blinker control off your steering wheel - i.e. plug in straight, try that, if no connect then shift it up like if you were turning your blinker on for a right turn, try again, then try shifted down like for a left turn. It might look like it's not plugged in straight, but that's how mine connects.
Wait, what? There's a Wisdom that handles deep stops??? Is this a firmware upgrade I can get for my existing Wisdom 2?