sunny_snake
Registered
Hello divers,
Please can you help? I have just replaced the seals on the condensate valves on the bottom of the P0 chamber and now the compressor seems to be constantly leaking (not sure what else to describe) out of the bleed port situated between the condensate drain valves. The new seals are fitted the correct way round and screwed in tight (not overly tight). There is a filter in the P0 chamber and I am getting pressure up and air delivery out of the whip...just not very quickly...please could you help out as to why this is happening...
I only changed the seals in the condensate valves as they needed to be overly tightened to stop air loss and slow fills...this only started after starting the compressor following the stated process in the manual about letting the compressor build up to operating pressure before filling cylinders...
Any advice would be greatly appreciated!
Cheers,
Andrew.
Please can you help? I have just replaced the seals on the condensate valves on the bottom of the P0 chamber and now the compressor seems to be constantly leaking (not sure what else to describe) out of the bleed port situated between the condensate drain valves. The new seals are fitted the correct way round and screwed in tight (not overly tight). There is a filter in the P0 chamber and I am getting pressure up and air delivery out of the whip...just not very quickly...please could you help out as to why this is happening...
I only changed the seals in the condensate valves as they needed to be overly tightened to stop air loss and slow fills...this only started after starting the compressor following the stated process in the manual about letting the compressor build up to operating pressure before filling cylinders...
Any advice would be greatly appreciated!
Cheers,
Andrew.