Ditziano
Registered
Hi there,
I’m playing around with my first backplate and harness, and came to the following set up for DSMB and Spool (direct bolt snap to the backplate)
I know it has been discussed, that the twisting can open the bolt snap by accident.
Nonetheless, I do not see that risk in this set up (bolt snap fits quite snug and does not seem able to turn and twist “on itself”)
I find it very easy to find the corner of the back plate and bolting and unbolting the double ender.
Any additional remarks/concerns you might see (apart from the, in my opinion, minimal Christmas tree dangling).
I attached a couple of pictures on how I set up the whole story (tip of the cable tie is only there to loop it easier through the hole)
Thanks!
Daniel
I’m playing around with my first backplate and harness, and came to the following set up for DSMB and Spool (direct bolt snap to the backplate)
I know it has been discussed, that the twisting can open the bolt snap by accident.
Nonetheless, I do not see that risk in this set up (bolt snap fits quite snug and does not seem able to turn and twist “on itself”)
I find it very easy to find the corner of the back plate and bolting and unbolting the double ender.
Any additional remarks/concerns you might see (apart from the, in my opinion, minimal Christmas tree dangling).
I attached a couple of pictures on how I set up the whole story (tip of the cable tie is only there to loop it easier through the hole)
Thanks!
Daniel