Firdaus Buhari
Registered
Hi all,
I managed to get a set of apeks SM regs which were pre assembled
2x din first stages
2x xtx 50s on a long hose and a short hose
2x 6" inflator hoses on the 5th port
2x spgs with 6" hp hoses
My question is my sms100 inflator comes out from the top over my shoulder and therefore the power inflator is pointing downwards in the epaulette/keeper and the insertion point for the LP hose is very awkward coming from the 6" LP hose from my 1st stage and it is too short...
A solution I figured was to switch the position of the dump valve from bottom to top but I prefer the dump valve at the bottom and also there are reports of many failures resulting in swapping the valves.
Does anyone else have this problem and have a solution for this, any input is welcome
I managed to get a set of apeks SM regs which were pre assembled
2x din first stages
2x xtx 50s on a long hose and a short hose
2x 6" inflator hoses on the 5th port
2x spgs with 6" hp hoses
My question is my sms100 inflator comes out from the top over my shoulder and therefore the power inflator is pointing downwards in the epaulette/keeper and the insertion point for the LP hose is very awkward coming from the 6" LP hose from my 1st stage and it is too short...
A solution I figured was to switch the position of the dump valve from bottom to top but I prefer the dump valve at the bottom and also there are reports of many failures resulting in swapping the valves.
Does anyone else have this problem and have a solution for this, any input is welcome