Thermoplastic Backplate

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Try here for the Apeks ultra-lightweight backplate …

Apeks WTX Ultralight Travel Plate
Thanks Umuntu for the link. I guess I should have been more clear in my original description. Ah, old age.... Since I've become an instructor I have aversion to paying retail costs. My shop orders through the local distributor and they are out of stock until long after I get back from vacation. It wasn't so much that it can't be had, I should have said, "it can't be gotten at the discount available to me through the store I teach at."

Thank you again though for the help with that link! -Dave
 
Probably too late to this thread however, I think HDPE would be a better material to use than Lexan. It would be slightly flexible, probably wouldn't require thermo-forming. My Zeagle soft plate is only 3/16 in. thick and totally flat. I used stainless steel "sidewalk" screws to mount straps.

Menards carries HDPE:

https://www.menards.com/main/buildi...92-c-14048.htm?tid=7805758314787279336&ipos=2

https://www.menards.com/main/buildi...11-c-14048.htm?tid=7805758314787279336&ipos=1

Here are what sidewalk screws look like:
sidewalk screws - Bing images
 
Just a heads up--thermoplastic such as Acrylite and Plexiglas releases flammable gases when heated to the temperatures you need to form it. Consequently you are supposed to use a "circulating air oven." I have done it successfully in my home oven without blowing up the house but it had some kind of fan in it. It's been a while but I think the amount of time to soften the plastic is more like 10-15 minutes, not hours. I have formed 3/4" acrylic and even blew my own dome port for my camera housing.

Also, I don't think 1/8" will be strong enough--I'd suggest 1/4" but it will weigh more. If you use a sharp drill bit it may cause crazing in which case it will probably break. I suggest using a grinder on a Dremel etc instead of drilling.

I am using the old style backpack with a snorkel vest for the wing and a plastic buckle and the whole thing only weighs about 2 pounds. It has around 15 pounds of buoyancy.
 
Last edited:

Back
Top Bottom