For me I get in the water and take the mask off for awhile at some point early in the dive. Face cools and lens cools to same temp and all is good.
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
++++ for Baby Shampoo and saves you a lot of $$. Spit is hard core and last resort......not very sanitary and higher risk for eye infection.
Well, it works fine for me every dive. All we want is a thin layer of shampoo film inside the mask.I don't rinse it, just wipe the shampoo with TP until it is clear to see. One problem you will have doing that is if you put the mask on your face and it's more than a couple of minutes before you enter the water, it will get streaky. Once in the water just let a little water in and clear the mask--streaks gone. If you have a long walk, or one over seaweedy rocks it's best not to have the mask on, but then we get into the old "MOF" thread.
Oh, I didn't mean "use whale **** to rinse your mask", I was merely making a point about eye infections. I think whale **** is likely to contain more dangerous bacteries (to us) than our saliva. And since you rinse it out, it's kind of in the same proportions that you'll end up in contact with it. Hence being scared of your own spit in your mask means to me that you prefer whale **** in contact with your eyes more than saliva.I didn’t try spit or whale **** yet but I will keep those ideas in my back pocket just in case.
Hi
I recently purchased 2 ScubaPro Orbit masks for myself and my wife. When I purchased them I used the toothpaste trick to clean the inside of the lens. I also used the flame of a lighter to try and make sure that I had burned off all of the coating. Last night we were doing some skills practice at an indoor pool and both masks kept fogging up. I tried mask defog several times on both of them but they continued to fog to the point that I could not read my dive computer. They would fog both at the surface and submerged. My first thought was simply the humidity in the enclosed pool area. However I noted that others were not having the same issue.
Any thoughts on how to deal with this?
Morgan